INSTRUCTION SHEET- F4D247
STEEL EQUIPMENT RACK 19" X 84", BLACK
INSTRUCTIONS
1. Lay side rails (1) on the floor.
2. Assemble base angle (2), and top
angle (3) as shown in Figure 1.
3. Turn rack over and repeat base and
top angles on other side.
4. Square legs. Tighten all bolts.
5. Mount to floor, using suitable
fasteners (see note below).
6. Install equipment using provided
screws.
NOTE:
-Due to variances in floors, shims may
be needed under base angles.
-To square legs, measure diagonally
between top and bottom bolts. The
distance between A and B should be the
same as C and D (see Figure 2).
FIGURE 2
BELKIN
TOOLS NEEDED:
1/2" wrench or socket
Measuring tape
#2 Phillips screwdriver
Parts List
ITEM QTY DESCRIPTION
1 2
Steel Rack Leg
2 2
Steel Rack Base
3
2
Steel Rack Top Angle
4 12
Hex Cap Screw 5/16-18 x 1
5 12
Flat Washer 5/16" 0.688 O.D.
6 30 Pan Head Phillips 10-32 x 0.5
Kommentare zu diesen Handbüchern