Belkin Range Extender/ Access Point Bedienungsanleitung PDF herunterladen (Seite 9)

Overview

Back Panel

Power Jack

Connect the included 4.5V DC power supply to this jack.

RJ45 Ethernet Jack

Connect an Ethernet cable to this socket, and connect to an open

RJ45 10Base-T or 100Base-Tx port on a switch, hub, or router.

Auto Connect Button

The “Auto Connect” button will automatically connect and set up your

WURE to a wireless network. It is as simple as pushing a button.

Reset Button

The “Reset” button is to be used in the unlikely event that your WURE

malfunctions. Resetting the WURE restores its normal operation while

maintaining the programmed “settings”. You can also restore the

factory default settings by using the “Reset” button. Use the restore

option if, for example, you have forgotten your password.

a. Resetting the WURE

Push and release the “Reset” button. The lights on the WURE

will momentarily flash. The “Power/Ready” light will begin to

blink. When the “Power/Ready” light becomes solid again, the

reset is complete.

b. Restoring the Factory Defaults

Press and hold the “Reset” button for 10 seconds, then release

it. The lights on the WURE will momentarily flash. The “Power/

Ready” light will begin to blink. When the “Power/Ready” light

becomes solid again, the restore is complete.

Rotatable Dipole Antenna

An omnidirectional dipole antenna is located on the back of the

WURE. The antennas can rotate 180 degrees. The antenna should be

oriented in the vertical position for best performance.



 







 



Power Jack

Antenna

RJ45 Ethernet Jack Reset Button

Auto Connect Button

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 56 57

Keine Kommentare

Belkin Range Extender/ Access Point Bedienungsanleitung Seite 9