Belkin F8T003V2SOFTWARE Betriebsanweisung PDF herunterladen (Seite 13)

PAY@PC • User Guide and Tutorial • 2.00.0629.2009 page 9

Setting up Devices

When you start PAY@PC for the first time, you will be asked to set up your hardware devices.

It is recommended that your review any documentation comes with your device(s) before installing or plugging

it into your computer. In many cases, problems can be avoided by following the steps outlined in your

hardware’s documentation or by installing the software that came with the hardware prior to attaching it to

your computer.

Similarly, PAY@PC works with Bluetooth 1.1 and 2.0 (or later) compliant devices. While PAY@PC has been

rigorously tested with numerous third party drivers and various operating systems, technology constantly

evolves. For this reason, PAY@PC has a Test Feature for each hardware device. Thus, the following is

recommended when installing any device to work with PAY@PC...

1. Start your computer and log on to your Windows OS as the System Administrator.

2. Read any documentation that came with the hardware that you will be adding to the computer.

3. Turn off any background software that might interfere with the installation of your hardware.

(i.e., Virus Checkers)

4. Install any software that came with the hardware according to the manufacture’s instructions.

5. If you are using any device that requires power, make sure that it is fully charged and/or plugged in.

6. If you are using a Bluetooth device, make sure that there is no interference within 3 feet (i.e., wireless

telephone or cell phone) and that the Bluetooth device is about 1 to 2 feet away from the computer.

7. Also make sure that you have the latest drivers, security patches and software on your computer.

8. Once you setup and attach the hardware to your computer, use the Test link located on setup screen

of for each device to make sure that it is functioning properly.

Special Note about using the Merchant On The Go Bluetooth Card Reader and Printer:

Some notebook computers include Bluetooth hardware. The Merchant On The Go works with the Microsoft and

Toshiba Bluetooth connection software that is included on some notebooks. The Merchant On The Go has also

been tested with the Kensington (# 33348) and Belkin (F8T003 ver 2) USB Bluetooth adaptors. When pairing

the Merchant On The Go using the Bluetooth software on your computer, you must select the Serial service

where you will be prompted to enter a passkey. The passkey is in your printer manual. You will also need to

assign a COM Port for this connection. When pairing the Merchant On The Go with your computer, follow the

Bluetooth Pairing instructions that came with your computer or particular USB Bluetooth Adaptor.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Keine Kommentare

Belkin F8T003V2SOFTWARE Betriebsanweisung Seite 13