Belkin Vision Wireless Router N1 Bedienungsanleitung PDF herunterladen (Seite 17)

1312

Knowing your N1 Vision

section

E. Connections to Wired Computers – Gray Ports

Connect your wired (non-wireless) computers to these ports.

These ports are RJ45, 10/100/1000 auto-negotiation, auto-

uplinking ports for standard UTP category 5 or 6 Ethernet cable.

The ports are labeled 1 through 4. Use the gray cable provided to

connect your computer to any one of these ports.

F. Connection to Modem – Yellow Port

This port is for connection to your cable or DSL modem. Use the

cable that was provided with your modem to connect the modem

to this port. Use of a cable other than the one supplied with the

cable modem may not work properly.

G. Reset Button

The “Reset” button is used in rare cases when the N1 Vision

may function improperly. Resetting the N1 Vision will restore the

N1 Vision’s normal operation while maintaining the programmed

settings. You can also restore the factory default settings by

using the “Reset” button. Use the restore option in instances

where you may have forgotten your custom password.

i. Resetting the N1 Vision

Push and release the “Reset” button. The lights on the N1

Vision will momentarily flash. The “Power/Ready” light will

begin to blink. When the “Power/Ready” light becomes solid

again, the reset is complete.

ii. Restoring the Factory Defaults

Press and hold the “Reset” button for at least 10 seconds,

then release it. The lights on the N1 Vision will momentarily

flash. The “Power/Ready” light will begin to blink. When

the “Power/Ready” light becomes solid again, the restore

is complete.

H. Power Jack – Black

Connect the included 12V/1.25A DC power supply to this jack.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 113 114

Keine Kommentare

Belkin Vision Wireless Router N1 Bedienungsanleitung Seite 17