Belkin F5U022 Betriebsanweisung PDF herunterladen (Seite 139)

When creating a new file, the largest size available is 2000 x 2000. If you enter dimensions

smaller than 16 or larger than 2000 pixels, this message will appear. Choose a different size

and try again.

R05 Error "Problem with scanner or camera software."

This message will appear when trying to use your scanner or digital camera if the device has

not been installed correctly. Close PictureStitch™, follow the manufacturer's instructions for

the Twain-compliant device, then reopen PictureStitch™ and try again.

R06 Error "Scanner or camera is in use by another application."

This message will appear when trying to use your scanner or digital camera if another

graphics program is already open that uses the Twain-compliant device. Close

PictureStitch™ and the other graphics programs, then reopen PictureStitch™ and try again.

R07 Error "Failure to acquire image due to unknown causes."

This message will appear in certain circumstances when trying to use your scanner or digital

camera, for example if the cable is disconnected during the scan or download. Close your

program, check the connections to your scanner or digital camera, then reopen the program

and try again.

R08 Error "Not enough memory to perform operation."

This message will appear when trying to use your scanner or digital camera if system

resources are low. Close other programs and try again. If this does not work, try restarting

your computer.

R09 Error "Could not load picture file."

This message could appears if the desired Image File is not where the program expects it to

be, for example if it was loaded into the program from a floppy disk, then closed and the

floppy disk removed. The message would appear if you try to load the design from the

Recent Files list on the File Menu. It could also appear if the file you are attempting to load is

corrupt. For example, it might have an extension such as .BMP or .JPG, yet not be a proper

image file.

R10 Error "You cannot select a region smaller than 5 x 5 pixels."

When using the Box Select or Freehand Select features, this message will appear if the area

you try to select is extremely small. Click and drag to select a larger area.

R11 Error "Could not save picture file."

When saving a picture file to a floppy disk, this message will appear if the Write-Protect tab is

activated. Take the floppy disk out of the drive, flip the tab the other way and try again. It

could also appear if the disk is full. This is most likely to occur when saving to a floppy disk;

use another disk. If the message appears when attempting to save to hard disk, delete some

files then try again.

FAQ Lists for Pfaff VIP Software Page 139

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 210 211

Keine Kommentare

Belkin F5U022 Betriebsanweisung Seite 139